The Lift & Rotate Unit is pre-adjusted before delivery. Precise adjustments have to be done with the pallet and its work piece together, and by adjusting the flat index pin to get the pallet properly supported.

Lift Locate Adjustments of flat index pin 1 2

 
To adjust the flat index pin, please proceed as follows:
  1. Disconnect the electrical and pneumatic supply of the entire conveyor system and secure against reconnection.
  2. Loosen the set screw at the adjustable flat rest.

    Lift Locate Adjustments of flat index pin 3

  3. Turn the flat index pin in or out according to the needed adjustments (with suitable tools). The index pin is pre-tensioned by spring washers to avoid self-turning.

    Lift Locate Adjustments of flat index pin 4

  4. Push the pallet including the work piece manually above the Lift & Rotate Unit, lift the pallet with the unit and check if the pallet has a solid support from the indexing plate.
  5. If the position is well defined, remove the pallet of the Lift & Rotate Unit and tighten the set screw to secure the rest position.
    If not, please adjust the heights again and follow steps 4 and 5 until the pallet sits properly on the index pins.