To install the Lift & Rotate Unit into the LOGO!MAT Roller Conveyor, please proceed as follows:
  1. Define the area where the Lift & Rotate Unit should be installed. Replace all full rollers with stub rollers in this area. (See the documentation of the roller conveyor for detailed installation operation steps.) The stub rollers on the driven side have to be installed with a 57 mm spacing; on the non-driven side a spacing of 114 mm is sufficient.
    The required stub rollers are not part of the scope of delivery. They have to be ordered separately in case of a component order.
    Oily conditions require a cross drive unit to drive both sides of the stub rollers.
  2. Remove the mounting clamps on one side of the base plate and loosen the remaining clamps.
  3. Slide the entire Lift & Rotate Unit [from below] with the remaining mounting clamps into the inner, lower slot of the conveyor bottom rail extrusion and reattach the removed mounting clamps enough so that movement of the entire unit is still possible.
    Pay attention that the direction of the conveyor flow (information on the drive station) and the arrow of the stop unit match.
  4. Push an empty pallet into the cushioned stop unit until the end position is reached and the return stop is locked.
  5. Check the position of the pallet and adjust the unit location if necessary.
  6. Tighten the mounting clamps of the Lift & Rotate Unit to the conveyor.
    The mounting clamps have to be locked into the extrusion correctly, to avoid movement of the unit.
  7. Install the drive unit of the Lift & Rotate Unit with electrical drive. Insert the drive unit into the conveyor extrusion, identical to step #2, and tension the drive chain (see chapter of "Tension the Drive Chain").
  8. Check for sufficient clearance of the horizontal stop movement manually and adjust the roller configuration if needed to avoid any pinch points or collisions with the rollers.
  9. Supply the pneumatic and electrical connections according to the wiring diagrams.
  10. Check and test the function of the entire Lift & Rotate Unit.