LOGO!MAT L - Series: Shuttle


Shuttle-1
Shuttle-2
Shuttle-3

The LOGO!MAT Shuttle is a unit to transfer pallets perpendicular to the main conveyor track. Manual and automatic single off-line workstations can be realized or two parallel conveyor tracks can become connected even if they run very close to each other. A static nesting table where the pallet gets lowered and indexed is available as one standard feature for the Shuttle.

To transfer the pallet out of the track it gets lifted pneumatically by just 25 mm above the roller level and then moved electrically to the other side of the Shuttle. The force needed for the motion is independent of the pallet weight, since we are using linear guide rails to support the linear movement.

The main conveyor track can be re-opened to traffic as soon as the pallet on the shuttle leaves the track, even if the shuttle is still moving the pallet. This advantage leads to low cycle times and high efficiency of the Shuttle.

Guarding is only necessary if required by the operating company. The installed friction clutch limits the side force to a minimum and the moving pallets can be easily stopped by hand with no pinch points.

As all our units, the Shuttle comes fully assembled and tested. The installation on site is done very quickly. Sensors and controls are normally not part of the scope of supply but with using our LOGO!MAT ITB Control Concept, you will get a proven turn-key solution.

Downloads
PDF Download
LOGO!MAT Shuttle
Technical Data Sheet

Download... 

Medien